MV-HDD a commercial capacity HDD destroyer.
The MediaVise® is a desktop data destruction solution standing only 25” tall and 12” wide. When a computer hard drive is “fed” into the MediaVise™, its patented crushing plates deliver over 40,000 pounds of force to the vulnerable platters and read heads of the drive. In less than a minute, the hard drive is crushed, mangled and rendered unreadable and discharged into a debris collection bin. The entire process is completely “hands off”.
The MV-HDD also destroys and renders inoperable, other miniaturized electronic devices and data storage media including SSDs, USB/flash drives, PDAs, cell/smart phones and circuit boards.
Key Benefits
-
Commercial capacity machine, yet portable, versatile and safe for deployment on a truck, or in an office or data center
-
Media destruction can be performed in-house so media never leaves your custody intact, or entrusted to a contractor
-
Simple, user friendly, automated operation.
-
No special adapters needed for power or for crushing various media
-
Crushing plates never need to be sharpened or replaced
Product Features
-
The MV-HDD utilizes proprietary MediaVise hydraulic crushing platform fitted with a pair of patented corrugated interlocking crushing plates.
-
The crusher delivers 20 tons (40,000 lbs) of destructive forces to mangle and destroy the HDD's magnetic data storage platters, controller and read heads in less than 30 seconds (see photos below).
-
Built-in Worker and Environmental Health and Safety features:
-
Fully automated, hands-off operation for user safety
-
Debris accumulates in a collection bin until safely disposed of
-
HEPA Filtration system traps any potentially harmful airborne particulates from the crushing and shattering of circuit boards, electronic components and silicon-based memory chips
-
RFI and EMI Suppression to minimize interference with other electronic equipment in the vicinity
-
Noise suppression to 65db which is much quieter than the 85db threshold acceptable to OSHA for workplace
Specification.
ModelMV-HDD
Machine Weight (Excluding packaging and crating)
170 lbs. – 110 volt model
185 lbs. – 220 volt model
Machine Dimensions
27” x 22” x 12 ¼ ” (H x L x W)
Shipping Weight
195 lbs. – 110 volt model
210 lbs. – 220 volt model
Shipping Dimensions
32” x 25” x 15 ¼ ” (H x L x W)
Power Requirements (voltage / frequency / current)
220 Volts A.C. ±10%, 50/60 Hz, 7.5 Amps
110 Volts A.C. ±10%, 50/60 Hz, 15 Amps
Factory Configured for any international power supplies
Maximum Media Size Destroyed
5.75” x 1.25” x 4” (H x L x W)
Full Crushing Cycle Time
30 seconds. Debris falls into debris bin. No need to clean machine after each use.
Media Accepted
Dedicated 2.5" & 3.5" HDD destroyer (no adapters required), cell phones, circuit boards, memory chips. Will also crush SSDs and make them inoperable but not to NSA standards.
Debris Collection
Debris falls directly into enclosed collection bin which holds up to 20 computer drives or 50 laptop drives.
Maintenance/Longevity
100,000 Cycles MTBF. No blades to be replaced or sharpened
Technical Support
On-call technical support service department; nationwide and international technical support team that can be deployed if and when repairs or maintenance needed.